4X4 PRO V2 paper calibration
Instructions for 4X4 PRO paper calibration. Serial number up to 14999 with only serial and parallel ports.
Measure the paper size
Measure the paper length in millimetres. The paper length is needed during paper calibration.
Start paper calibration with “Item + Power On”
Place a stack of paper in the sheet feeder
Press ”item” during power on until “beep, beep...” echoes
- First sheet will be feeded and the estimated paper length will be echoed out.
Give the correct measured paper length in mm, by pressing ”1” = +1 or ”10” = -1 (each step is 0.15 mm). Save the value by pressing ”setup”.
- A first empty page will be fed through the embosser.
- The second page will be fed and an askew row with dots will be embossed close to the page edge and the question ”give number of dots” will be echoed.
Count the number of dots on the paper. Give the number of dots with ”1”, ”10” and save it with ”setup”.
- A first empty page will be fed through the embosser.
- A second page is fed with a pre-folding line and arrow embossed.
Verify page layout
Press the “value” key and the embosser echoes the active page format (lines/page, characters/line). This information is required when setting up your braille editor.