Enable accessible mode
Enable accessible mode


Connect Index V5 to wired network-X

Connect the network cable
On the left side of the control panel there is a network icon. When connecting the network cable to the embosser, this icon starts to flash during the search for a network address. After a few seconds the network icon will light up in which indicates an established network connection.

Verify network address
By pressing HELP+10 the embosser will echo the TCP/IP address (example If the echo is there no network communication established.

Administration of an IP addresses
For more information about available TCP/IP addresses in your network contact the system administrator.

Here are instructions on how to set-up a network.