Enable accessible mode
Enable accessible mode

or

Setup Wi-Fi network from control panel

1. Current Wi-Fi network. Press OK to disconnect or forget the current Wi-Fi network.
    If there is no active network, speech feedback: "No Wi-Fi network active".
2. List known Wi-Fi networks. Press OK.
    Speech feedback: "Scanning for networks," and known networks available.
    Press Arrow up/down to select the network. Press OK to open a new menu: to connect or forget.     
3. List Wi-Fi network supporting Wi-Fi protected setup
    Speech feedback: "Scanning for networks", and "found the number of networks supporting WPS", e.g.  "Found 3 networks".
    Click Arrow up/down to get the list of network names.
    Press OK to activate WPS on the embosser.
    Click WPS button or router to activate WPS. The Wi-Fi will then be connected. 
4. List all Wi-Fi networks. Speech feedback: "Scanning for networks," and list of networks detected by the embosser.
    Press Arrow Up/Down to get the list of network names.
    Press OK to select the network.
   
    Press Feed to scan network.
    For known networks, there are 3 options to choose from: connect, disconnect or forget.
    Speech feedback: "Starting wireless protected setup for network name".
    For unknown networks or networks that do not support WPS, there is a speech feedback: "Can't connect".