Hammer Replacement V4-X
Complete a hammer test by pressing Help + ON on the front panel of the V4 embosser. If you receive a result in which shows one or more hammers (solenoids) in which are faulty you will then want to replace the faulty hammer. To replace a faulty hammer within the embosser head consult the film below:
Note: It is important that the correct hammer connected to the embosser board is replaced and repositioned back into its original position as well as connected to the correct cable connector on the embosser board for proper functionality. After replacement you may complete a hammer test to ensure all cables and hammers have been replaced properly.