Enable accessible mode
Enable accessible mode

Knowledge base


or

Now viewing all documents in category Network Clear filter

Network

Network setup from Embosser Utility V3-X

Setup network parameters with embosser utility. First establish communication, for example via an USB port. Embosser utility enables setup of all network parameters.

Give permanent IP-address V3 embosser-X

This section describes how to give an Index embosser a permanent IP-address. Index recommends the use of a static IP address for simplicity sake when connecting to a Braille embosser. Index Embosser: Firmware 12.02 and higher Server: MS Windows 2000 server Client: MS XP or Vista

Create network port V3-X

In order to install the embosser to a network, you must create a network port. This describes how to create a network printer port in Windows and connect it to the IP address of your Index embosser. Index Embosser: Firmware 12.02 and higher Server: MS Windows 2000 server Client: MS XP or Vista

Change from USB to network V3-X

The following defines the simplest method to connect the embosser to a network in which the embosser has already been installed via USB-port.