Enable accessible mode
Enable accessible mode

or

V4 Error table 1.3.9

ERROR - Table Firmware 1.3.9

100: IPC - Configure ->press OK to continue
101: IPC - Timeout ->press OK to continue
102: IPC - Restart ->press OK to continue
103: IPC - Clear queue->press OK to continue
120: Out of paper -> insert paper and press OK
121: Paper jam -> remove paper and press OK
122: Paper length fail
123: Paper tray empty -> insert paper and press OK
130: Service door open
131: Paper tray open
132: Braille tray open
133: No tray / door signal open
200: Spool file - error
201: Spool file - empty
202: Spool file - unknown ESC sequence
203: Spool file - WinBraille esc sequences not supported
210: Spool file - V3 format esc sequences not supported
211: Spool file - V2 format esc sequences not supported
212: Spool file - min value
213: Spool file - max value for parameter in esc sequence exceeded
214: Spool file - max characters per line
215: Spool file - max lines per page 
216: Spool file - to many transparent characters
220: Spool file - unknown parameter
299: Spool file - formatting error
300: Not a valid file (Checksum error)
301: Not a valid magic number
302: Not a valid header
500: Undefined hardware setup
501: Allocate memory error
502: Free memory error
800: No SD-memory available
801: SD-memory Read only ->press OK -> power on restart -> not OK change SD card
802: No factory settings
810: Configuration - corrupt
811: Parameter - corrupt
812: Layout - corrupt
813: Header - corrupt
814: Network - corrupt
999: Restart
700: Ink timeout
701: Ink startup
702: Ink power up
703: Ink Power down
704: Ink post service 

IPC = Internal Protocol for Communication between the Linux master CPU and the lower lever CPU controlling the stepper motors and hammers.

Spool file errors (200-299) -> press OK emboss with exceeded paprameter values, or press ON to cancel document