Enable accessible mode
Enable accessible mode

or

V4 Error table - 1.4.1

 Error Table - 1.4.1

 
100: communication not configure
 101: communication timeout
 102: restart communication
 103: reset printing queue 
 120: Out of paper
 121: Paper jam
 122: Paper length fail
 123: Paper tray empty
 130: Service door open
 131: Paper tray open
 132: Braille tray open
 133: No tray signal open
 134: Braille tray full
 135: Paper jam - release
 150: No dynamic ip address
 200: document  receiving error
 201: document  file empty
 202: document  unknown esc sequence
 203: document  winBraille file
 204: document  xml format
 205: document  html format
 206: document  post script file
 210: document  v3 format
 211: document  v2 format
 212: document  min value
 213: document  max value
 214: document  max char per line
 215: document  max lines per page
 216: document  to many transparent characters
 220: document  unknown parameter
 221: document  missing parameter
 299: document  formatting error
 300: upgrade file checksum error
 301: upgrade file has not a valid magic number
 302: upgrade fil has not a valid header
 400: undefined hardware setup
 401: alignment board not working
 500: undefined software setting
 501: allocate memory error
 502: free memory error
 503: large document error
 800: no sd card available
 801: sd card is read only
 802: no factory settings
 810: configuration file is corrupt
 811: parameter file is corrupt
 812: layout file is corrupt
 813: embosser header file is corrupt
 814: network file is corrupt
 999: restart embosser
 700: Ink timeout
 701: Ink startup
 702: Ink power up
 703: Ink Power down
 704: Ink postservice
 900: test missing layout file
1000: information message
1001: save test document
1002: format document test failed
2000: warning message